Uniform heating for thick wall preform

Mon, 01 Jun 2026 19:25:06 +0800

On the floor, thick-wall preforms don’t cut you any slack when the heat isn’t even. You spot it fast—haze, stress marks, and a bottle that folds when it hits the drop test. When the heating tunnel can’t do its job, your Sidel, Krones, SIPA, Husky, SACMI, or Nissei ASB blow molder backs off just to chase tolerance. What matters, technically We design the emitter around the heating job, not around a generic spec. For thick-wall preforms, we lean on short-wave infrared—high power density and fast response—so the wall gets up to temperature before the surface starts scorching. The lamps are engineered to a 1:1 match with mainstream blow molders: 2400 W, 230 V, Ø10 mm quartz tube, and R7s connector geometry. The filament layout and reflector spacing are tuned to hit ±2% axial temperature uniformity across the neck and shoulder—exactly where thick sections tend to lag. Why it works in practice Because the dimensions and electricals line up with the OEM, the swap is straightforward. You keep the same heating tunnel footprint, the same mounting points, and the same control logic. That means predictable stretch behavior on thick walls, fewer rejects from uneven biaxial orientation, and cycle speed that stays stable without overheating the neck ring. Plants also report fewer lamp changes and measurable energy savings, since the system heats faster and holds setpoint with less drift. The things you’ll learn the hard way if you don’t watch them Quartz output shifts with tube temperature, so ambient airflow around the heating tunnel matters. Keep the reflector chamber clean and make sure the airflow path is doing its job, so the lamp runs where it was designed to run. Also, check the lamp socket condition on your machine—pitted contacts and cracked end caps can hide the real issue and give you inconsistent ignition.

Uniform on Ultimate IR Home Heating Comfort

Uniform heating for thick wall preform