Replacement lamp for SIG Blomax 6

Mon, 20 Jul 2026 10:33:34 +0800

Getting Your Sidel Blomax Heating Just Right

If you’ve ever run a PET blowing line, you know the headache of uneven heat. It’s a nightmare. To keep things consistent, your lamps have to fit the original setup perfectly. No gaps, no wobbles. That’s why we built our replacement lamps to slide right into any Sidel machine—whether you’re still rocking the old SBO models or you’ve moved up to the Matrix series. Here is the thing about the technical side. We didn’t just “approximate” the specs. We matched the wattage and voltage of the Blomax 6 power supplies exactly. Why? Because if the voltage is even a little bit off, you’re asking for trouble. You’ll either burn through your lamps way too fast or find that your preforms just aren’t getting hot enough. Then there’s the fit. We kept the mounting geometry standard. When you swap a lamp into a Matrix oven, the heat hits the preform exactly where it’s supposed to. If you’re off by just a few millimeters, you get cold spots. And cold spots mean thin walls in your bottles, which is the last thing you want. What are these things actually made of? We use high-purity quartz glass. It’s tough. It can take the constant heating and cooling of a blow-molding environment without cracking under the pressure. We also added a specific coating to the glass. Instead of the heat bouncing off the surface, it actually sinks into the PET material. Plus, we reinforced the end-caps to stop the electrodes from shifting. It keeps everything stable, even when you’re pushing the machine to its absolute limit. A quick word of honest advice. These lamps put out a lot of heat. A lot. Because of that, you’ve got to keep your oven’s ventilation and cooling systems clean. If your fans are clogged with dust, the heat builds up and will kill any lamp—no matter how well it’s made. One more tip: before you wire everything up, check your contact points for any oxidation. Cleaning those off prevents the terminals from overheating, which saves you a lot of grief down the road.

SIPA SFR 6 infrared lamp bulb

Sat, 27 Jun 2026 03:41:17 +0800

On a running blow molder, the heating tunnel is where you make or break the schedule. Uneven preform temps? You’re chasing scrap. If a lamp burns out mid-run, you stop the line, throw off oven balance, and scramble for a replacement that might not match the original. We built the SIPA SFR 6 infrared lamp to keep your heating profile stable, shift after shift. Here’s what’s under the hood: it’s a short-wave infrared emitter, engineered specifically for the SIPA SFR 6 heating zone. Quartz envelope, halogen filament—fast response and repeatable output. That gets the preform surface hot quickly and lets the core catch up without overshoot. The lamp is spec’d to fit the OEM’s power and voltage window, and it terminates with the correct R7s connector for a straight swap-in. In practice, that means you get the tunnel back to setpoint faster after a lamp change, and you run with less temperature drift across the row. And here’s why it matters: it restores the machine’s intended heating behavior. With stable infrared output, preform temperature stays under tighter control, which keeps stretch and blow consistent—fewer thin walls, fewer rejects, less rework. The fast warm-up helps you get back up to speed after a short stop, and the controlled spectrum keeps unnecessary heat off surrounding components, which can help cut energy per bottle. One practical note: infrared lamps live in a brutal thermal environment. Keep the reflector clean and aligned, and make sure the holder contacts are tight. If airflow is blocked or the connection is weak, lamp life will suffer. The SIPA SFR 6 footprint is a match, but always verify your machine revision and socket condition before installation.

6 on Ultimate IR Home Heating Comfort

Replacement lamp for SIG Blomax 6

Getting Your Sidel Blomax Heating Just Right

SIPA SFR 6 infrared lamp bulb