Introduction
We built this foot warmer because factory floors get brutally cold. Seriously, bone-deep cold. It’s not some fancy gizmo—it’s a tough, high-intensity halogen lamp, made for the grit of industrial work. It zeroes in on the one spot that matters: the cold floor right under your operators. They get the warmth they need, right where they stand, without wasting energy heating the whole plant.
Technical Deep-Dive
Here’s the thing about this heater: it runs on 400V. That’s just the standard voltage in most industrial plants, so it’s a simple plug-and-play fit. And because it pulls 2500W, it gets hot—fast. We’re talking serious, steady heat that can fight off those drafty, chilly corners. The whole unit is just 300mm long. That means you can tuck it in the tight spots—under a workbench, alongside a machine base—wherever you need it.
Material & Design
Inside, you’ve got a shortwave halogen element housed in a quartz tube. It’s built to deliver a ton of heat in a small space, and it holds its own through endless on-off cycles. The tube has a special coating to cut down on glare and shield the filament from all the grime and dust flying around on the shop floor. This thing is made to take a beating. And for wiring? We made sure it uses an R7s connector, so you can just swap it in for your old fixture. No hassle, no rewiring headaches.
Application & Benefits
Picture this: your operators are on their feet for hours. This heater is built for that exact scenario—running continuously, keeping them comfortable. That 2500W power hits exactly where you need it, turning a miserable, cold spot into a bearable one. But, and this is important, that kind of power needs its space. Make sure the fixture has plenty of airflow and clearance around it. You want to keep the heat focused on the floor, not cooking the components nearby.